Roland XP-10 - Makine Ocala Tae Settings Iticc Ee. T Thot Cawsisdcaari Eevee Tact Cu Lisees Eaten Atiastunausadcd Ages Veaaceasieonasaeal; Trine Seca TUBS AOIN7 Ol Ax Caisra Iiss Sore Tioonintt Sancti Etcdsevataahltart Mechta Bret Tchessic Tuts Sath Solent Eakbas

Chapter 3. Convenient performance functions
Making Scale Tune settings
You can adjust the Scale Tune settings to make a vari-
ety of scales. These settings allow you to make fine
adjustments in 1 cent (1/100th of a semitone) to the
pitch of each note C-B.
1. Press [EDIT].
The indicator will light.
2. Use VALUE[-]/[+] to select “System Setup” and
press [ENTER].
3. Press [7] several times to select “Scale Tune C” —
“Scale Tune B.”
* If you hold down [ENTER] and press [7], you will
return to the previous item.
* You can also select the note whose pitch you wish
to change by playing a note on the keyboard.
4. Use VALUE[-]/[+] to set the value (-64-+63).
5. Press [EDIT].
The indicator will go off, and the previous display
will reappear.
Setting examples
Here are examples of scales based on a root of C.
Note name Equal Pure Arabic Scale
Temperament Temperament (C)
Cc Q 6
CH 0 8 +45
D 0 +4 -2
D# 0 +16 -12
E 0 -14 -51
F 0 -2 8
F# 0 -10 +43
G 0 +2 4
G# 0 +14 +47
A 0 -16 0
A# 0 +14 -10
B 0 +12 -49
* In this example, the Arabic Scale can be played in
the three keys of G, C, and F.
Turning Scale Tune on/off
This can be set independently for each Part. When
Scale Tune is turned off, that Part will use Equal
Temperament.
1. Press [EDIT].
The indicator will light.
2. Use VALUE[-]/[+] to select “Perform Part” and
press [ENTER].
3. Press [7] several times to select “Scale Tune.”
* If you hold down [ENTER] while you press [7], you
will return to the previous item.
4. Use PART [<@]/[B> ] to select the Part for which
you want to make the setting.
* You will be able to select only two Parts (Upper Part
and Lower Part) if the Keyboard Mode (p.19) is set
to Dual, X-dual, or Split.
5. Use VALUE[-]/[+] to switch the setting
“ON” / “OFF”.
* If you wish to make settings for other Parts, repeat
steps 4-5.
6. Press [EDIT].
The indicator will go off, and the previous display
will reappear.
33