Roland XP-10 - Chapter 5. Restoring the Factory Settings (Initialize); Restoring All Settings to the Factory Condition (Factory Preset); Tect a Nace Meee Aarti Th Eats Stl S Lade a C Cuustottath Gual, Deel Nhalttnes; Restoring Specific Types of Settings to the Factory Condition (Tone;Drum Set Initialize, Performance Initialize)

Chapter 5. Restoring the factory settings (Initialize)
No matter how you modify the settings of the XP-10,
or edit the sounds, you will always be able to bring
back the following four types of initial or basic set-
tings.
Caution
When you execute Factory Preset, Tone/Drum Set
Initialize, or Performance Initialize, the settings of the
User area (the location where the settings you make,
such as User Tones etc. are held) and System Setup
settings will be lost. If you wish to preserve your
important settings, use the “Bulk Dump (All)” func-
tion to save the settings to a sequencer, etc. (Refer to
chapter 10, “Using a sequencer or computer to save
XP-10 settings (Bulk Dump)” p.57.) After you have
saved your data, use one of the following procedures
to initialize the desired type of data.
Restoring all settings to the fac-
tory condition (Factory Preset)
This operation will restore all User Tone, User Drum
Set, User Performance and System Setup settings to
the factory condition.
Procedure
1. Press [UTILITY].
The indicator will light.
2. Use VALUE[-]/[+] to select “Initialize” and press
[ENTER].
3. Use VALUE[-]/[+] to select “Factory Preset.”
* To cancel the procedure, press [UTILITY]. The indi-
cator will go off, and the previous display will reap-
pear.
4. Press [ENTER] to execute the operation.
5. When the factory data has been restored, the dis-
play will indicate “Completed” and the [UTILITY]
indicator will go off.
Restoring specific types of set-
tings to the factory condition
(Tone/Drum Set Initialize,
Performance Initialize)
These operations let you reset the User Tone/Drum
Set data or the User Performance settings to the facto-
ry settings.
Tone/Drum Set Initialize (User: Tone/Drum)
This will reset the 256 User Tones and the 20 User
Drum Sets to the factory settings.
Performance Initialize (User: Performance)
This will reset the 64 User Performances to the factory
settings.
Procedure
1. Press [UTILITY].
The indicator will light.
2. Use VALUE[-]/[+] to select “Initialize” and press
[ENTER].
3. Use VALUE[-]/[+] to select “User: Tone/Drum”
or “User: Performance.”
* To cancel the procedure, press [UTILITY]. The indi-
cator will go off, and the previous display will reap-
pear.
4. Press [ENTER] to execute the operation.
5. When the factory data has been restored, the dis-
play will indicate “Completed” and the [UTILITY]
indicator will go off.
37