Roland XP-10 - Using the Combination Palette Sliders to Modify the Sound; What Can be Controlled by the Combination Palette Sliders; Setting the Function of the Combination Palette Sliders; About Tie AP

Chapter 3. Convenient performance functions
Using the Combination Palette Sliders
to modify the sound
What can be controlled by the Combination
Palette Sliders?
The sliders can control one of the following six combi-
nations of functions.
Functions assignable to the Combination
Palette Sliders
F-LFO | LFO-R
Slider 1: TVF DEPTH LFO
apply modulation to the brightness of the sound
Slider 2: RATE CONTROL LFO
adjust the speed of modulation
A-LFO | LFO-R
Slider 1: TVA DEPTH LFO
apply modulation to the volume
Slider 2: RATE CONTROL LFO
adjust the speed of modulation
CUTOF | RESO
Slider 1: CUTOFF
adjust the brightness of the sound
Slider 2: RESONANCE
adjust the tonal character of the sound
ATTCK | RELES
Slider 1: ATTACK TIME
adjust the Attack Time (p.34)
Slider 2: RELEASE TIME
adjust the Release Time (p.34)
CHORS | REVRB
Slider 1: CHORUS DEPTH
adjust the depth of the Chorus effect
Slider 2: REVERB DEPTH
adjust the depth of the Reverb effect
RS-CO | PORTA
Slider 1: RESO-CUTOFF
produce a “wah” effect
Slider 2: PORTA TIME
adjust the Portamento Time (p.26)
Setting the function of the Combination
Palette Sliders
1. Press [EDIT].
The indicator will light.
2. Use VALUE[-]/[+] to select “Perform Common”
and press [ENTER].
30
3. Press [9] several times to select “SLIDER Asgn.”
* If you hold down [ENTER] while you press [9], you
will return to the previous item.
4. Use VALUE[-]/[+] to select the functions that the
sliders will control.
PERFORM SLIDER
Asgn:F-LFO|LFO-R
Slider 1's function
Slider 2's function
* When you move the sliders, the function and value
of each slider will appear in the display.
5. Press [EDIT].
The indicator will go off, and the previous display
will reappear.
* Depending on the sound and the slider functions,
the effect may not be very noticeable for some
sounds.
About the XP-10’s controllers
The XP-10 provides the following controllers; Pitch
Bender, Modulation Lever, pedal (either an expres-
sion pedal or a pedal switch), and Combination
Palette Sliders.
The functions that can be controlled by each con-
troller have been explained in chapters 2 and 3, and
can be summarized as follows.
A)
When the Keyboard Mode is X-dual, X-dual can be
controlled using either the Modulation Lever, the
pedal, or the Combination Palette Sliders (“Changing
the X-dual controller” p.20).
B)
When an arpeggio is being played, the arpeggio pat-
tern can be controlled using the Pitch Bender or the
Combination Palette Sliders (“Changing the arpeggia-
tor pattern while you play” p.24).
Cc)
The pitch of the sound can be controlled using the
Pitch Bender (“Raising and lowering the pitch in real-
time (Pitch Bend) p.28).
D)
Various aspects of the sound can be changed as you
play, using the Modulation Lever, the pedal, and the
Combination Palette Sliders (“Modifying the sound in
realtime while you play” p.28).