Roland XP-10 - Page 20

Chapter 2. Playing the XP-10
* When the Keyboard Mode is Single, using PART
[ <@ ]/[ > | to switch Parts will modify the value of
“Upper Part.” If after switching Parts, you change
the Keyboard Mode from Single to Dual etc., the
setting of “Upper Part” that you selected as
explained in this “Selecting Parts” will also be
changed. In this case, you will need to set the
“Upper Part” once again.
Changing the X-dual controller
In addition to the Combination Palette Slider 1, X-
dual can also be controlled by an expression pedal
(sold separately: EV-5 etc.) or by Modulation Lever.
Slider or Expression Pedal is convenient when you
want to play a mixture of the two Tones.
Lf Slider is selected, Slider 1 will control X-dual and
Slider 2 will control Pan (stereo position). As you
move Slider 2 away from you, the stereo position of
the two Tones will move from L to R.
If Pedal is selected, you will need to connect an
expression pedal (sold separately: EV-5 etc.) to the
XP-10. It is not possible to use a pedal switch (sold
separately: DP-2/6, FS-5U etc.) to play a mixture of
the two Tones.
* If you have selected Slider to control X-dual, the
function (X-DUAL for slider 1, PAN for slider 2)
and current value of each slider will be displayed
after you set the Keyboard Mode to X-dual. This
display will also appear while you are moving the
sliders.
Slider 1 Slider 2
X-DUAL [| PAN
L22| UllIL {15k
Lower Part Left Right
Upper Part
*%
The function and current value of each slider will
also be displayed for several seconds when you
switch the Keyboard Mode to a mode other than X-
dual.
%
These sliders do not always control X-dual and Pan.
Their function changes depending on the status of
the XP-10. For details refer to “About the XP-10’s
controllers” (p.30).
20
1. Press [EDIT].
The indicator will light.
2. Use VALUE[-|/[+] to select “Perform Common”
and press [ENTER].
3. Press [9] several times to select “X-DUAL Ctrl.”
* If you hold down [ENTER] as you press [9], you
will return to the previous item.
4. Use VALUE[-]/[+] to select the controller (PEDL,
MOD, SLDE).
5. Press [EDIT].
The indicator will go off, and the previous display
will reappear.
A quick way to change the X-dual controller
Hold down [X-DUAL] and press [EDIT] to jump
directly to the “X-DUAL Ctrl” page. Make settings as
explained in steps 4-5 of the above procedure.
If you wish to quickly change the X-dual controller,
you can also hold down [X-DUAL] and press
VALUE[-]/[+] to modify only the “X-DUAL Ctrl” set-
ting. When you release [X-DUAL], the previous dis-
play will reappear.
Setting the Split Point
The Split Point can be set in the range of C2-C#7.
TN nN TUTE
Noa (Split Point)
Lower Zone Upper Zone
1. Press [EDIT].
The indicator will light.
2. Use VALUE[-]/[+] to select “Perform Common”
and press [ENTER].
3. Press [8] several times to select “Split Point.”
* If you hold down [ENTER] as you press [8], you
will return to the previous item.
4. Use VALUE[-]/[+] to set the Split Point (C2-C#7).
5. Press [EDIT].
The indicator will go off, and the previous display
will reappear.