Roland XP-10 - Page 68

Chapter 12. Appendix
RA ana ee ee PL a a I a IS EAE FE OC EE, RTE
Performance parameters set for each Part (Perform Part)
Parameter Name Value
Level 0—127 (100)
Pan RND, L63—R63 (0)
Chorus Depth O—127 (0)
Reverb Depth Q—127 (40)
MIDI Rx Channel 1—16, OFF (same as part number)
Tune Key Shift -24—+24 (0)
Scale Tune ON, OFF (OFF)
keyboard Velo Sens O—127 (64)
Solo Switch ON, OFF (OFF)
Porta Time OFF, 1—127 (OFF)
Control Bend Range O—+24 (+2)
VoiceResv O—28 (Part 1=6, Part 2—10=2, Part 11—16=0)
Tone Type TONE, DRUM1, DRUM2 (Part 10=DRUMI, Parts except Part 10=TONE)
Tone parameters (Tone)
Parameter Name Value
Vibrato Vib Rate -50—+50 (0)
Vib Depth -50—+50 (0)
Vib Delay -50—+50 (0)
Filter FilterCutoff -50—+16 (0)
Filter Reso -50—+50 (0)
Envelope Env Attack -50-—+50 (0)
Env Decay -50—+50 (0)
Env Release -50—+50 (0)
Drum Set parameters (Drum)
Parameter Name Value
Pitch -24—+24
Level Q—127
Pan RND, L63—R63
Reverb Depth O—127
Parameters affecting the entire XP-10 (System Setup)
Parameter Name Value
MIDI Local ON, OFF
Rx GS Reset ON, OFF
Rx System Excl ON, OFF
Tx PerformDump ON, OFF
Tx UserBankSel ON, OFF
Device [ID# 1—17—~32
Slider1 CC# 1—16—31, 64—95
Slider2 CC# 1—17—31, 64—95
Pedal CC# 1—4—31, 64—95
CTS/RTS ON, OFF
Tune MstrKeyShift -24—O—+24
MasterTune 415.3—440.0—466.2 (440.0)
ScaleTune(C—B) -64—0—+63
Control LCD Contrast 1—2—4
Bold : factory setting
() : GS initial setting (GS Reset)
Parameters without () are not affected by receiving a GS Reset.
a oo