rollease acmeda AUTOMATE ARC - Initial Set-up; Pair Motor with Controller; Check Motor Direction

8 | Automate™ Programming Instructions | ARC™ Venetian Tilt Motor ROLLEASE ACMEDA
Select channel on
controller.
(Disregard if using single channel
controller)
Hold P1 button on motor Hold STOP on controller
IMPORTANT
Motor Response Motor Response
Consult user manual for your
controller for information on
selecting channel.
RELEASE P1
Motor is now in setup mode and ready for setting limits.
4 INTIAL SETUP
4.1 Pair Motor with controller
4.2 Check motor direction
To check travel direction of shade, press UP or
DOWN on controller.
To reverse shade direction, hold both UP
and DOWN until motor responds
Motor Reponse
Reversing motor direction using this method is
only possible during initial set-up, prior to first time limit
setting, or after a re-set of motor