Safety devices
Caution! Safety devices serve to protect the user and may not be modified or bypassed.
Mains switch/mains plug
The mains switch/mains plug disconnects the power supply from the system.
Control board fuse
The fuse prevents the overloading of the motor.
Motor thermoprotector
The thermoprotector prevents the motor from overheating.
Control board pulse limiter
The pulse limiter prevents the motor from working if there is no pulse signal from the motor to
the controller.
Control board kill switch (public pools)
The kill switch prevents the motor from working insofar as the key switch is not operated
continuously until the respective position is reached.
Key switch/programming switch
The key switch locks the system and prevents the system from being operated unintentionally or
by unauthorised persons.
Intended use
Rollo Solar motors are intended for underwater use in private and public swimming pools.
Installation and start-up must be performed by a qualified specialist. The motors must be
connected according to the Rollo Solar installation guidelines. Only controller approved by Rollo
Solar may be used. The power supply must be between 24–30 volt DC. The operating
temperature of the motor is between 0 °C and 40 °C. The systems may only be operated by
authorised persons with the proper training. The motors are to be used in pool water with a
quality corresponding to DIN 19643 for non-swimmer pools. The saline concentration agreed
with the retailer/customer and Rollo Solar may not be exceeded in the case of swimming pools
operated with saline water.
To Next Page
Loading...