Rollo Solar RT 400 - User Manual

Installation
Manual
Tubular Motors
RT 200
RT 400

Summary

Installation Guidelines and Electrical Work

Electrical Work and Safety Precautions

Initial Start-up, Scope, and Tools

Tools and Accessories for Installation

Safety Devices and Intended Use

Safety Device Overview

Overview of safety mechanisms and their functions to protect users and the system.

Intended Use and Application

General Operating and Safety Instructions

Installation Procedures

Electrical Work Precautions

Installing the RT 200 Motor

Installing the RT 400 Motor

Cable Routing: Drive to Clamping Flange

Installing the Counter Bearing

Preparing the Distribution Box

Inserting the Drive Cable

Connecting Cable: Distribution Box to System

Cable Connection: 7 to 9 Cores

Cable Connection: 5 to 9 Cores

Grounding the Distribution Box

Connecting Drive and Connecting Cables

Sealing the Distribution Box with Gel

Transformer and Motor Fuse Components

Replacing the Motor Fuse

Connecting Controller to Cables

RSC3;RSC4 Circuit Diagram

DIP Switch Configuration for Public Pools

Connecting the Braking Resistor

Status Indicators and Control Buttons

Programming End Positions

Connecting the Key Switch

Connecting the PS1 Switch

Connecting the RSC Wireless Module

Programming Radio Receiver;Transmitter

Connecting the Filter Pump Lock

BUS;EIB System Connection

Troubleshooting: Error Course of Action

End Positions Not Stopping Correctly

Troubleshooting steps for when end positions are not reached accurately.

Troubleshooting: Switch Unresponsive

Troubleshooting: Handheld Transmitter Unresponsive

Error: Controller Not Programmed

Error: Emergency Mode Active

Error: Thermoprotector Active

Error: Motor;Pulse Generator Fault

Error: Undervoltage Detected

Emergency Mode Activation and Deactivation

Rollo Solar RT 400 Specifications

General

Brand	Rollo Solar
Model	RT 400
Category	Engine
Language	English