RollSeal SW 100 - Page 17

Part No. 4801-5329 Rev 3-09 SW 100 Sidewall Curtain System Page 17
Clearance of 1/4"-1/2"
(6.35mm -12.7mm)
between tension pipes
Outside panel
Front bar
Roller
Inside
Tension
Pipe
Outside
Tension
Pipe
Fasten
material
with pan-
head screw
Back plate
Raise or lowe
r
panel material
Outside
p
anel
Side view of SW 100 door
Interior parts
Center panel
Inside panel
Center panel
(shown relaxed)
Figure 18 - Door Panel Adjustments
To adjust the height of the outside tension pipe, raise or lower the outside door panel by removing the pan-head
screws, detaching the panel hook & loop from the front bar, and raising or lowering the panel. Then re-attach the
panel loop to the hook on the front bar. Be sure to keep tension pipe level during this procedure. Reinstall the pan-
head screws through the panel material and into the front bar to securely hold the material in place.
To adjust the height of the inside tension pipe, raise or lower the inside door panel by loosening the three nuts,
detaching the panel hook & loop from the back plate, and raising or lowering panel. Then cut new holes through the
panel material for the pem-studs and re-attach the panel loop to the hook on back plate. Install the nuts and washers
to the back plate securely in the same order as removed to hold the material in place. Be sure to keep the tension
pipe level during this procedure.
Hook & loop
Inside panel