GB
3
3. Installation and removal in the vehicle
3.1. with ISOFIX fastening
After adjusting the shoulder belts (refer to 4.1) fasten the child seat with ISOFIX
as follows:
1. Prepare ISOFIX
Clip the two insertion guides* 1 to the two
ISOFIX fastening points 28 of the vehicle
seat (between seat and backrest). The
cutout must point upwards.
1
1
28
1
28
Using the green handle 2, pull the two
connectors 3 as far as they will go.
2
3
On both sides of the seat squeeze the
locking button 5 and the red release
button 6 together and remove the
connector protection 33.
33
5
6
* The insertion guides make it easier to fit the child seat with ISOFIX
and avoid damage to the seat cover. They should be removed when
not in use and kept in a safe place. In vehicles with folding down
backrests, the insertion guides must be removed before folding down
the backrest.
Any malfunctions are usually caused by dirt on the insertion guides
and on the hooks. This problem can be solved by cleaning these
points.
part number: 09163186 ( GM ) / 93181287 ( Vauxhall )
To Next Page
Loading...