HOW TO CLEAN AND MAINTAIN YOUR CHEF N GO
After cooking, it is advisable to clean the CHEF N GO as well as the spatula
and spoon to remove leftover food and odors. Always remember to unplug the
CHEF N GO before cleaning. Use a damp sponge (non-abrasive) and a mild
dish washing soap.
Remove the steam valve from the unit by lifting, using the lip on the valve and
twisting up. On the back of the valve is a switch, move the switch to the open
position which will allow you to open the valve for cleaning. Insert the steam valve
back into the upper lid with the hinge of the steam valve toward the rear of the
CHEF N GO and push down.
The Steam Valve
3
Mount
Remove
Gently remove the inner lid’s circular steam seal (do not twist or pull). Once it
has been removed, clean it in warm soapy water. You can also place this in the
dishwasher as it is dishwasher safe. Once dry, put the steam seal back into the
groove, adjusting it until correctly positioned. To reassemble, align the base with
the lid making sure that the two hinges are correctly positioned. The two pieces
should snap right into place. Move the hinges back toward the lid into the closed
position until you hear it click. This will connect the two pieces.
The Inner Lid Steam Seal
All of your accessories are dishwasher safe. To hand wash the Bowl Gripper, Egg
Poacher, Silicone Muffin molds, and Ronco’s famous Chef Knife; simply place in your
dishwasher or clean with a mild dish soap, sponge and water and dry thoroughly
before using again in the CHEF N GO. All of the additional accessories such
as the Extendable Colander, Slotted Spoon, Silicone Wisk, Silicone Ladle, Silicone
Ladle Holder, Silicone Spatula and the Silicone Measuring Cups, can also be cleaned
in the dishwasher or with a mild soap and non-abrasive sponge. Dry thoroughly before
each next use.
The Accessories
To Next Page
Loading...
