RCP-ME User Guide (v4.0) DashBoard Interface Overview • 81
DashBoard Interface Overview
This chapter outlines the interfaces, menus, and parameters available in DashBoard for the RCP-ME.
RCP-ME Connection Editor Fields
The RCP-ME Connector Editor interface displays in DashBoard when you double-click the second sub-node listed
in the RCP-ME tree. This interface enables users to establish the RCP-ME network settings, such as the IP Address
and TCP Port, assign the panel to a router group, and specify a unique identifier for the panel to be used in the
DashBoard interfaces.
The RCP-ME can have up to three more NK-NETs configured as backups in the event that connection is lost to
the primary NK-NET.
Figure 16.1 Example of the RCP-ME Connection Editor
Device Details Area
The Device Details area is located in the top portion of the RCP-ME Connection Editor. This area displays
information that identifies the RCP-ME within your routing system. Table 16 .1 briefly summarizes the fields
displayed in the Device Details area.
Table 16.1 Device Details Area
Item Parameters Description
Serial Num (read-only) # The serial number is set in the factory before
shipping and is unique to each device.
Version (read-only) #.# Displays the software/firmware version
Hardware Rev
(read-only)
# The hardware version of the RCP-ME
To Next Page
Loading...