RCP-ME User Guide (v4.0) DashBoard Interface Overview • 83
In the event that the RCP-ME is unable to connect to a server or loses connectivity, it will attempt to connect to
the next server after 10 seconds. For each server that the RCP-ME fails to connect to, it will attempt to connect to
the next available server until it arrives back at the original server to which it attempted to connect.
Connections Area
Displays the number of clients connected to the RCP-ME.
Bottom Toolbar
The bottom toolbar of the RCP-ME Connection Editor displays the following buttons:
•
Refresh — Reverts to the configuration previously sent to the RCP-ME. The RCP-ME Connection Editor will
display the last settings that were sent to the RCP-ME via the
Send Configuration button.
•
Send Firmware — Opens a file browser to select a software/firmware file to send to the RCP-ME.
•
Send Configuration — Uploads the settings to the RCP-ME.
All configuration items become active only after uploading by sending the configuration to the device.
•
Reboot — Reboots the RCP-ME. This function does not clear the RCP-ME settings.
•
Close — Closes the RCP-ME Connection Editor in DashBoard.
Panel Config Interface
The Panel Config interface enables you to setup device details, assign panel button, menus, I/O, and macros.
Figure 16.2 Example of the RCP-ME Panel Config Interface
Table 16.3 Servers to Connect to Area
Item Parameters Description
Servers # The order priority of the servers
IP Address #.#.#.# The IP address of the server
Connected (read-only) Selected There is a connection to the specified server
Cleared No valid connection to the specified server
To Next Page
Loading...