84 • DashBoard Interface Overview RCP-ME User Guide (v4.0)
Top Toolbar
The Device Details area is located in the top-right corner of the RCP-ME Panel Configuration Editor. This area
displays information that identifies the RCP-ME within your routing system. Table 16.4 briefly summarizes the
fields displayed in this Device Details area.
Simulated RCP-ME Panel Area
The RCP-ME Panel Config interface displays a representation of the RCP-ME hard panel. (Figure 16.3)
Figure 16.3 Example of an RCP-ME Hard Panel in DashBoard
1. Function Buttons
This area represents the function, source, and/or destination buttons configured for the RCP-ME. Click a button
to open the Button menu to assign a function to the button.
2. Hide Panel Button
Click this button to hide the simulated RCP-ME panel.
Table 16.4 Device Details Area
Area Item Parameters Description
Serial Num (read-only) # Displays the serial number is set in the factory
before shipping and is unique to each device
Version (read-only) #.# Displays the software/firmware version
Device Details Name (read-only) <text> Displays the unique identifier for the RCP-ME as
specified in the RCP-ME Connection Editor.
Group (read-only) # Displays the group number assigned by the user to
organize devices into groups. For example, users
can assign separate group numbers for devices in
different physical area.
Details (read-only) <text> Displays the additional information the user
provided in the RCP-ME Connection Editor. For
example, a physical location or a brief description
of its use.
Address # This address is used within the overall control
system to identify NK devices using resource
management and protects. Each device must be
given a unique T-BUS address to avoid
communication conflicts
a
.
The valid value range for assigning an individual
device T-BUS address is 1-255
a. Except when panel-linking is used.
To Next Page
Loading...