ULTRIX-MODX-IO User Guide (v1.0) Configuration • 39
Matte Gen Disable Disable an internally generated test pattern. This is
the default.
Static Generates a static color matte
Bouncing Box Generates a static color matte with a
complimentary colored moving box
Luma Sequence Generates a luminance shifting sequence based on
chosen color
Matte Format # Specifies the signal format of the generated test
pattern. If you select Auto, the test pattern
automatically matches the incoming signal type.
Matte Color # Specifies the color of the test signal
Audio Bypass Selected When Audio Bypass is enabled for an input, the
audio will follow the SDI regardless of any individual
audio channel routing or configuration on the
output.
The individual channels of an input in Bypass mode
are still de-multiplexed and available for audio
routing via the audio matrix.
Cleared Disables this feature
Sub-Image ID 3G Some legacy equipment does not accept a 2SI
SMPTE-352 payload identifier for quad-link SDI. You
may need to select this if you are connecting legacy
equipment to the specified output on the
ULTRIX-MODX-IO.
2SI Set the SMPTE-352 payload identifier to 2SI for
quad-link.
Clean Switch
Status
(read-only)
Locked The specified output is locked to its input.
Not Locked The specified output is not locked to its input.
Clean Switch Selected Clean Switch is applied to the specified output. The
Clean Switch Delay value is applied.
Cleared Clean Switch is not applied to the specified output.
Clean Switch
Mode
Reference Clean Switch is based on the reference signal
available on the REF port of the router
Input Clean Switch is based on the input signal available
on the specified port of the router
Clean Switch
Delay
# Specifies the Clean Switch buffer depth. Select
between 1/16 to full line to clean switch between
signals with slight timing offsets.
Trigger # Specifies which reference signal trigger to use. Refer
to the user guide for your router.
Table 3 Port Configuration — Views > Ports
Item Parameters Description