AC-020 Page 35 03/02
NOTE: You must be in NORMAL mode to
program the AC-020. DOOR 1 / DOOR 2
LED will be green.
Wrong or timed out entries will reset the
controller to the NORMAL mode
condition.
To exit programming, press the “*/#” key
for two seconds. Three beeps are
generated and the system will return to
NORMAL mode. A short press on the
“*/#” key will also return the system to
NORMAL mode, and a long beep will be
heard. This aborts the programming, but
in some cases, such as Program
Function #7, data may have already
been programmed.
Wrong entries during programming may
also abort programming, along with long
beep generation.
All programming operations are done
either from the on-board keyboard or
from the reader. Programming the
PROX. employee codes requires using
proximity reader and proximity cards.
To Next Page
Loading...
