Controller Operation
AYC-Ex5/T65 Series Installation and Programming Manual 51
The Code Search method only works if a user’s Primary code is
already enrolled but the Secondary code is not (see
Section 4.9.12.5).
4.9.12.4 Enrolling Primary and Secondary Codes using Standard
Method
To enroll Primary and Secondary codes using the Standard method:
1. Enter Programming mode.
2. Press 7 to enter Menu 7.
The right LED turns orange.
3. Enter the 3-digit user slot number between
001 and 500 that you wish to enroll a
Primary or Secondary code to.
For example, User Slot 003 represents User
#3.
If the selected slot has no Primary code
left LED flashes green, indicating that the
controller is ready to accept a Primary code.
If the selected slot already has a Primary
code but no Secondary code, the left LED
flashes red, indicating that the controller is
ready to accept a Secondary code.
If the selected slot already has a Primary
and Secondary code, you hear a long beep
and the controller returns to Normal mode.
Orange
To Next Page
Loading...
Need help?
General
