11. Installation
28
117592 ● 03/2013
c) Assembling the latch cable
To make this step easier, raise the slider
block to the top position.
Feed the end of the cable into the latch control
cable clamp on the primary column and tighten
the clamp (see Fig. Fehler! Verweisquelle
konnte nicht gefunden werden.).
Feed the other end of the cable upwards
through the sheave to the latch cable clamp of
the secondary column.
The control cable is routed in the column.
Screw the mechanical safety lever onto the
primary column latch.
Adjust the tension of the cable with the clamp so
that both latches disengage from their rack at
the same time when you pull the latch
mechanism lever.
d) Assembling the arm
24
i
i
To Next Page
Loading...
