11. Installation
29
117592 ● 03/2013
CAUTION
When assembling the bolt
Pinch point
Keep hands above the nut
Before installing the arms, bring the slider
block to a suitable height.
Lubricate the sweep arm pins and holes with
lithium grease. Insert the arm into the bracket.
After attaching the arms and the bolts, attach
the guide mechanism as follows:
25
Attach the guide motor as per Fig. 26after
assembling the arms and the bolts (Fig. 25).
The guide bolts can now be tightened as in Fig.
27.
26
To test the function of the arms after assembly,
raise the slider block at least 25 mm from the
bottom position. Pull up the bolt ring and bring
the arms into the desired position.
To engage the guide, drop the bolt ring so that
the teeth can engage.
It may be necessary to gently rotate the arm so
that the teeth can engage.
27
i
Pinch point
Note: Pay attention to the
orientation of the bevelled gear!
To Next Page
Loading...
