d04095
page 11 - 2
Jan. 01/2007
Effectivity: 447 SCDI, 503 DCDI,
582 DCDI
OM Edition 1 / Rev. 0
BRP-Rotax
11.1.3) At out of service periods or storage of engine for longer than 4
weeks up to 1 year
– proceed with preservation prior to engine stop and on the
engine at operating temperature
– let the engine run at increased idle speed
– remove air filters and inject approx. 6 cm
3
of preservation oil or
equivalent oil into the air intake of each carburetor
– stop engine
– remove spark plugs and inject approx. 6 ccm preservation oil
or equivalent oil into each cylinder and slowly turn crankshaft
2 to 3 turns by hand to lubricate top end parts. Refit spark plugs.
– drain gasoline from float chambers, fuel tank and fuel lines.
– drain coolant on liquid cooled engines, to prevent any damage
by freezing
▲▲
▲▲
▲ WARNING: Generally comply with standard rules for handling
of chemicals. Dispose of chemicals as per local
enviromental regulations.
– Lubricate all carburetor linkages.
– Close all openings of the engine like exhaust end pipe, venting
tube and air intake to prevent entry of dirt and humidity.
– spray all external steel parts with engine oil.
To Next Page
Loading...
