Rotax 912 i series

To Next Page

To Previous Page

d07068.fm

SI-912 i-029 / SI-915 i-012

SI-916 i-007

SERVICE INSTRUCTION

08 February 2024 74-20-00

Initial Issue Page 7 of 15

3.5.1) Double ignition coil - removal

1 Allen screw

2 Washer

3 Cable clamp

Fig. 2

Step Procedure

1 Disconnect the negative terminal of the battery.

2 Remove the cable clamps with Allen screws and lock washers from the intake mani-

fold, if necessary.

Step Procedure

3 Cut the cable tie from the exhaust gas temperature sensor cable (cyl. 1_3) connected

with the double ignition coil cable.

WARNUNG

NOTICE

Do not damage the cables. Always cut cable ties on the side of the support

plate facing away from the cables.

Rotax 912 i series - Page 7