Rotax 912 i series - Page 2

d06703.fm
SI-912 i-024
SI-915 i-006
SERVICE INSTRUCTION
03 July 2019 76-10-00
Initial Issue Page 2 of 18
Copyright - BRP-Rotax GmbH & Co KG. All rights reserved.
1.7) Labor time and credit
Estimated labor hours:
Engine installed in the aircraft - - - labor time will depend on airframe installation and therefore no
estimate is available from the engine manufacturer.
1.8) Mass data
Change of weight - - - none.
Moment of inertia - - - unaffected.
1.9) Electrical load data
No change.
1.10) Software modifications
No change.
1.11) References
In addition to this technical information refer to current issue of
- Illustrated Parts Catalog (IPC)
- Installation Manual (IM)
- Maintenance Manual Line (MML)
- Maintenance Manual Heavy (MMH)
NOTE: The status of the Manuals can be determined by checking the table of amendments.
The 1
st
column of this table shows the revision status. Compare this number to the one
listed on the ROTAX website:
www.flyrotax.com
. Updates and current revisions can be downloaded for free.
1.12) Other Publications affected
None.
1.13) Interchangeability of parts
All parts are interchangeable with relevant modifications.