www.rotexautomation.com
Mounting Instructions (rotary actuator):
1. Attach the mounting bracket to the smart Positioner using the Hardware items indicated in
the figure above.
2. Attach the coupling securely using grub screws as indicated in the figure above.
3. The assembly is then mounted on the actuator (refer figure 6 below) while taking care that
the shaft enters in the slot of the actuator pinion.
4. Assembly of Positioner and actuator should allow the play between shaft and pinion and never
between actuator body and bracket.
5. Secure the bolts tightly and proceed for calibration.
Figure 6: Mounting the Positioner on a rotary actuator
To Next Page
Loading...