www.rotexautomation.com
8.3.2. Calibration
Calibration
Applicable for Posidapt – Modern, Expert, Super, Ultra and IPST
Use this parameter to initialize automatic calibration process. If the device is not calibrated
initially, only value "Auto1" is allowed for calibration.
• Auto1- Recommended
It sets all the parameter which needs to be calibrated in order for valve system to operate as
desired.
• Auto2
It calibrates only start point or 0.0% & end point or 100.0%.
• Auto3
It calibrates PID parameter in order to optimise the operation of the valve system.
• Manual
It calibrates PID parameter with manual values.
To Next Page
Loading...