Rotex Posidapt Series - Mounting Positioner with bearing assembly on a Rotary Actuator

RTX-IOM-PRODUCT-YY
Page 29 of 131
www.rotexautomation.com
6.4. Mounting Positioner with bearing assembly on a Rotary Actuator.
This section gives the instructions needed for mounting the positioner to a rotary actuator
(part turn actuator).
Table 3 below gives a list of components required for the installation.
Table 3:
Sr. No.
Part description
Quantity
Note
1
Shaft and bearing
assembly
1
2
Grub screw M6 X 45
4
For attaching Positioner to bracket
3
Nut M6
4
For attaching Positioner to bracket
4
Coupler
1
Link between Positioner and actuator
5
Grub screw M5 X 10
2
For attaching coupling to shaft
6
Standard bracket
1
7
Nut M5
4
For attaching bracket to actuator
8
Grub screw M5 x 20
4
For attaching bracket to actuator