Rotex Posidapt Series - Mounting Positioner on a Rotary Actuator

RTX-IOM-PRODUCT-YY
Page 26 of 131
www.rotexautomation.com
6.3. Mounting Positioner on a Rotary Actuator:
This section gives the instructions needed for mounting the positioner to a rotary actuator
(part turn actuator).
Table 2 below gives a list of components required for the installation.
Table 2.
Sr.
No.
Part
description
Quantity
Note
1
Std Mounting
bracket
1
2
Plain washer M6
4
For attaching Positioner
to bracket
3
Hex Bolt M6 x
12
4
For attaching Positioner
to bracket
4
Plain washer M5
4
For attaching bracket to
actuator
5
Hex bolt M5 x 12
4
For attaching bracket to
actuator
6
Grub screw M5
X 10
2
For attaching coupling
to shaft
7
Coupling
1
Link between Positioner
and actuator