www.rotexautomation.com
Using “Zero point soft stopper” & “End point soft stopper” parameters causes two different
scaling types, Position & Scale, for display & position feedback parameter “Feedback
direction”. Refer the following figure.
• Position- Factory default
This parameter value shows the mechanical position from 0.0% to 100.0% between the actual
mechanical stops of the actuator irrespective of the “Zero point soft stopper” & “End point soft
stopper” parameters.
• Scale
This parameter value shows the mechanical position from 0.0% to 100.0% over the range of
“Zero point soft stopper” & “End point soft stopper” parameters. This results in proportional
scale of display & position feedback.
The following example shows a 90
0
part turn actuator angle of rotation dependence on the
scaling (“Soft stopper display scaling”) as well as “Zero point soft stopper” & “End point soft
stopper” parameters.
To Next Page
Loading...