www.rotexautomation.com
• Off - Factory default
This parameter value does not trigger any message or alarm.
• Custom
The threshold 2 fault message is displayed when the limit threshold 2 is exceeded. The value
can be set from 0.1 to 20.0%.
Threshold Limit 3
Use this sub-parameter to set the factor for the formation of limit threshold 3.
• Off - Factory default
This parameter value does not trigger any message or alarm.
• Custom
The threshold 3 fault message is displayed when the limit threshold 3 is exceeded. The value
can be set from 0.1 to 20.0%.
Dead-band Monitoring
Applicable for Posidapt –Super and Ultra
This parameter is used to determine the basic control accuracy of the valve.
The current dead-band value is displayed in the “Dead-band” in Values and Counters under
Counter Thresholds and Trends. The device triggers a fault message if the value exceeds
one of the three configurable limit thresholds.
Threshold Limit 1
Use this sub-parameter to set the factor for the formation of limit threshold 1.
• Off - Factory default
This parameter value does not trigger any message or alarm.
• Custom
The threshold 1 fault message is displayed when the limit threshold 1 is exceeded. The value
can be set from 0.1 to 20.0%.
Threshold Limit 2
Use this sub-parameter to set the factor for the formation of limit threshold 2.
• Off - Factory default
This parameter value does not trigger any message or alarm.
To Next Page
Need help?
General