CD32 - Radio Tuning
135
3
RADIO PRE-SET BUTTONS
The six pre-set buttons (3) can be used to manually store up to
eighteen FM stations (six each on FM1, FM2 and FMT), six MW
stations and six LW stations.
Programming the pre-sets
• Press the waveband selector (1) to select the required waveband
or memory bank (FM1, FM2, FMT, MW or LW).
• Using the tuning buttons (2), select the desired frequency (see
‘RADIO TUNING’, page 133).
• Press and hold one of the pre-set buttons (3). The radio will
mute briefly while the frequency is being stored. If ‘BEEP ON’
has been selected (see ‘MENU CONTROL FUNCTIONS’,
page 140), an audible ‘beep’ will confirm that the frequency has
been stored.
• Release the pre-set as soon as radio sound is restored and the
new frequency details are displayed.
Operating the pre-sets
Once the pre-set buttons have been programmed, select the
desired waveband, then press the pre-set button of your choice.
The display will initially show the pre-set number you have
selected and the station frequency e.g: ‘P3 101.3’. This is followed
by the waveband and station frequency (or station name).
AS0032
2
31
To Next Page
Loading...
