Security Code
181
3
Harmony and Symphony audio
• Switch on the radio (‘CODE’ appears in the display). Press pre-
set button 1.
• Press either the up or down tuning button until the first digit
of the security code appears in the display. Press pre-set 1 to
store the first digit in the unit's memory.
• Use either tuning button to select the second digit of the code
(until the correct digit appears in the display). Press pre-set 1 to
store the second digit.
• Select the third digit, again using the tuning buttons (until the
correct digit is displayed). Press pre-set 1 to store the third digit.
• Select the final digit (the display now shows the full four digit
code). Press pre-set 1 to store the final digit.
If the correct code has been selected the radio will commence
operating immediately.
NOTE: If an incorrect code has been entered, the first time delay period
commences. During the delay period, ‘CODE WAIT’ appears in the
display - DO NOT switch off. At the end of the delay period, ‘CODE’
reappears in the display and you can then enter the correct code. Remember;
the time delay period doubles each time an incorrect code is entered.
To Next Page
Loading...
