EasyManua.ls Logo

Rover 75 Saloon - Page 51

Rover 75 Saloon
285 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Parking Heater
51
1
Changing the preset running time
Press and release both the ON and OFF buttons simultaneously
three times in quick succession. The indicator light flashes as
described above. Within 10 seconds, press the OFF button, to
increase the running time by 10 minutes - the indicator light will
flash the correct number of times to confirm the new running time
(one flash for 10 minutes, two flashes for twenty minutes et.c.).
Continue to press and release the OFF button until the desired
running time is reached. To set the new running time, either
briefly press the ON button, or do not press any button for 10
seconds - the new running time is now set.
To return the running time to its default value (30 minutes), press
and hold both the ON and OFF buttons simultaneously for 10
seconds, at which point the indicator light will extinguish.
EFFECTS OF CAR BATTERY DISCONNECTION
If the car battery is disconnected or discharged for a short time, the
timer control unit's programmed time settings and presets will be
lost (the control unit display flashes). The time and preset settings
will need to be re-entered before the system will operate
automatically (see SETTING & OPERATING THE PARKING
HEATER, page 47).
If the car battery is disconnected or discharged for a prolonged
period of time, the remote handset may lose synchronisation with
the control unit. Although this is unlikely, the handset can be
resynchronised by following the procedure detailed below.
SYNCHRONISING THE HANDSET/
PROGRAMMING ADDITIONAL HANDSETS
If the remote handset has lost synchronisation with the parking
heater receiver (if the car battery has been disconnected for a
prolonged period, for example), or if an additional handset is to be
programmed, the handset will need to be synchronised.
Disconnect the negative lead on the car battery for a minimum of
5 seconds. Reconnect the negative lead and, within 2 seconds,
press and hold the handset OFF button for a further 2 seconds
(approximately). The handset indicator light will flash once to
confirm that the handset is now synchronised correctly. If the light
fails to flash, repeat the above procedure.
NOTE: Up to 2 additional remote handsets can be synchronised for use
with your parking heater. Replacement or additional handsets can be
ordered through your MG Rover dealer.
IMPORTANT
To avoid inadvertent drain on the car battery, it is not recommended
that the preset running time be increased from the default
(30 minutes), except in extreme conditions.

Table of Contents

Related product manuals