RS PRO ILOM-508A - Feature; General

Milliohm Meter/ English
EN-2 2016-9-10 / V001
Feature:
 Very low impedance measurement by Four Wire type one pair coated clip.
 There is a fuse (0.5A/250V) to protect the input circuit.
 Applicable measurement of Resistance, Motor coil, Transformer, Printed Circuit
Board.
 Accurate measurement of conductor, light electricity and welding point.
 Wide measurement range, 0.1 mΩ to 20kΩin 6 positions.
 D – H Switch: Lockup readings for LCD display.
General:
 Display:
3-1/2 digits, LCD display with max. reading of
1999 with decimal point and measurement
unit.
 Overload indication:
“OL” indication.
 Zero Adjust:
External zero adjust knob.
 Low battery indication:
Replace battery as LCD display “ ”.
 Reading speed:
2.5 times per second.
 Operating attitude:
Max. 2000 meters above level.
 Operating ambience:
In-door use, under environmental pollution
grades two
 Operating temperature and
R.H. value:
5°C to 40°C, 80%RH or lower.
 Storage temperature and R.H.
value:
-10°C to 60°C, 70%RH or lower.
 Power supply:
1.5V × 6 NEDA 15F IEC R6 Alkaline battery.
 AC adapter (not included):
An optional accessory with the specification
required as followings:
AC input voltage: 100V AC to 240V AC 0.3A
with input frequency of 60 HZ or 50HZ.
DC output voltage: 9V DC.
DC output current: 0.5A DC.
Socket: pin ground casing positive with
external diameter 3.5mm and internal
diameter 2.0mm.
 Dimension and weight:
160 x 100 x 52mm. approximate 500g.
 Accessories:
Carrying case, one set of testing clips and
instruction manual.
 Fuse specification:
0.5A/250V, 5Ø x 20mm. FAST MIN
INTERRUPTS RATINGS 1500A.