22
m)
Pass the end of the spinnaker halyard around the sheave and through the cleat as
shown, and tie knot #3 in the tail.
Remember to secure the other end of the spinnaker halyard near the base of the mast.
4.6.5 - Dressing the Mast - Halyards
o)
n)
Remember to secure both ends at the bottom
of the mast once the halyard is tted.
Add the snap shackle to the other end of the spinnaker
halyard (the end emerging from top of the mast).
If you are using the club spinnaker, lead
the other end of the halyard back down from
the head of the mast and pass it through the
metal casting on the front face of the mast
(approximately 75mm from the mast head).
If you are using the race spinnaker move
straight on to the next step.
To Next Page
Loading...
