30
d)
e)
4.8 - Rough Rig Setting
Attach one end of your tape measure to the main halyard and hoist it to
the top of the mast, keeping the other end in your hand.
Take the end of the spinnaker halyard in youir other hand and lead it aft to the top
of the transom and pull it tight. Using the spinnaker halyard as a guide to keep the
tape measure straight, measure the distance from the top of the mast to the top
back edge of the transom (above the rudder gudgeon).
Pull on the backstay.
You should be aiming to set the mast rake so that this distance is 9550mm.
9550 mm
Measure to this point.
To Next Page
Loading...
