3.7 - Rigging the Kicker
• Take the cascade rope and mark where it will attach to the single jam block with
becket (see diagram below).
• Tie the cascade rope onto the jam block using knot #6
• Thread the long end through one of the 20mm blocks and then back through the
jam cleat block and through the jammer.
block using knot #1
• Tie knot 3 in the end of the line
To rig the kicker, you will need:
• x2 20mm blocks
• x1 Single Jam Block and Becket
• Kicker cascade rope - 4mm Evo Performance - 2300mm
Adjust the cow hitch on
the jam block to maintain
peak performance of
the kicker.
Knot #6
Knot #3
Knot #1
4mm Evo Performance
2300mm
Single jam block
with becket
20mm
Block
20mm
Block
200mm
The standard kicker will come as standard with the boat, if you have the Race
pack, refer to the instructions included within to rig the race kicker.
To Next Page
Loading...
