3.10 - The Rudder
To complete this section, you will require:
• The rudder
• The rudder stock
• The Tiller
• The Tiller retaining screw
• The Tiller extension
a)
b)
c)
• Remove the rudder assembly from the foil pack and locate the components.
The self-tapping screw is in a small bag, in with the tiller arm.
• Slide the Tiller into the stock
• Tie a 20mm downhaul block onto the rope from the Rudder blade
• Attach the tiller extension to the tiller.
To Next Page
Loading...
