RS Feva - Hoisting the Jib

Now step the mast, following the instructions in Section 3.5 - Stepping the Mast.
3.12 - Hoisting the Jib
Once the mast is stepped in the boat, you should attach the
shrouds to the shroud adjuster plates. A good setting to start with is
with the pin in the third hole down on the shroud adjuster plate.
HINT
The mast on the RS Feva is supported at deck level by the mast gate and the
foredeck. The shrouds
applied to the jib halyard, hence making the jib work better. Therefore, changing
the shroud
when tension is applied to the jib halyard.
i)
j)
• Unroll the jib.
• Take the tail of rope sewn into the tack of the jib,
and pass it through the metal loop on the tack bar.
• Pass the tail through the webbing loop sewn
onto the tack of the jib.