As soon the water is deep enough, make sure that you lower the rudder blade fully by pulling
hard on the rudder downhaul. You will know it is fully down if you feel a gentle “thud” as
the front face of the blade hits the front face of the stock. Cleat the downhaul and tidy it by
winding it around the tiller. Pull the sail in and you are away!
For the best performance, you should ensure that you and your crew position yourselves so
Watch the trim (fore and aft) and the heel. The boat should always be sailed as upright as
possible.
Top Tip
As a general rule, sit further forward in lighter winds and further aft in stronger
breezes.
4.3 - Leaving the Beach
4.4 - Sailing Close-Hauled and Tacking
When sailing close-hauled, or as close as possible to the wind, it is important to get the
boom as near as possible to the centreline, especially when sailing the RS Feva XL with
the mainsail and jib
on, quickly put the boat head to wind. You should hold the tiller extension across your body,
cleat when
adjusting the mainsheet.
The jib sheet should be pulled in fairly hard when sailing upwind – tighter in stronger winds
and less so in lighter winds. Sail to the jib tell-tails, keeping the one on the back of the sail
streaming and the one closest to you either streaming or lifting upwards slightly.
To tack, push the tiller extension away from you and, as the boat starts to turn, step across
the cockpit facing forwards. Once the boat has completed the turn, bring the tiller back into
the centre before sitting down on the new side, with the tiller extension behind your back.
When you are settled, swap the mainsheet and the tiller extension into the new hands.
HINT
When sailing single-handed, sit with a leg either side of the thwart area when sailing
close-hauled or reaching. If there is a lull in the wind, simply slide your backside
If the boat slows right down and feels lifeless when close-hauled, you could be sailing too
close to the wind. Ease the mainsheet
the boat going again.
To Next Page
Loading...
