RS Feva - 3.2 Loading; 3.3 Safety Equipment

3.4 - Rigging the Jib
a)
b)
c)
To complete this section, you will need:
• 1 x Feva jib
• 2 x Feva shrouds
• 1 x shroud shackle
• 1 x jib halyard block
• 1 x jib halyard
• 1 x jib sheet
• 1 x jib halyard block tie
Before stepping the mast you will need to complete the following steps:
• Hook the eyelets at the end of the shrouds onto the shroud shackle.
• Attach the shroud shackle to the lower of
the two metal rings on the front face of the
mast.
• Tie knot #1 in one end of the jib halyard block tie.