• With the gennaker on the port side of the boat, thread one end
of the gennaker sheet through the block by the port-side shroud
adjuster plate.
h)
i)
i)
j)
• Take the other end of the gennaker sheet, pass it around the front
of the jib, and into the block on the other side.
• Pull the gennaker from one side to the other, as if you were gybing, to see if anything
is twisted.
• Finally, pull the gennaker down into the gennaker chute.
3.13 - Rigging the Gennaker
• Tie the two ends of the gennaker sheet together.
To Next Page
Loading...
