AUDIO DISTRIBUTION
21
www.rticontrol.com
Option Description
Max Volume
Set the max allowable volume level (relative) of a zone that can be achieved via
all interfaces and APIs. Volume levels that are attempted to be set higher than
this value will defer to the maximum level set here and an error will be shown in
the GUI.
Test Tone
Various test tones can be enabled per zone that are an excellent tool for uses
such as testing audio connectivity and signal path, setting/adjusting volume
levels, or properly aiming directional speakers, to name a few. The following
noise options are available:
• White Noise: Contains audio noise with an equal amount of audio intensity,
not loudness or energy, across the entire frequency spectrum.
• Pink Noise: Contains noise with an unequal amount of audio energy with
lower frequencies having a higher intensity due to the reduction of amplitude
that is linearly applied as frequencies increase.
• Gray Noise: Contains noise with a perceived amount of equal loudness
across the frequency spectrum based on the human auditory range, however
this noise is presented as a general approximation and will be perceived
dierently as each person’s hearing ability varies.
Test
Press the test button to begin emitting the selected noise out of a zone. Press
this button again to discontinue the noise.
To Next Page
Loading...