AUDIO DISTRIBUTION
7
www.rticontrol.com
Installation
Rack Installation
The AD-1616 matrix is shipped with rack-mounting accessories. This matrix
will consume 2RU or rack-mounting space. By default, the matrix is
shipped with attached footpads for installation in a cabinet or on a
shelf. These feet are not required to be removed for rack installation
when keeping a 1RU space below the unit for proper ventilation. These
feet can be removed if desired. Please use the included hardware to attach
the rack-mount ears to the matrix’s chassis.
Please note that a 1RU space should be maintained above and below the chassis, when
possible, to allow the ow of air to provide proper ventilation for the product. Failing to do so may
cause the unit to operate at a higher temperature and may lead to a shortened lifespan or damage/
failure.
Cabinet / Shelf Installation
Place the matrix on a shelf or cabinet that has at least 6” (15cm) of space on both sides, behind,
and above to allow proper ventilation and allow air to circulate and dissipate heat. If placing in a
cabinet, please ensure that there is adequate ventilation, either passive or active, so that the ambient
temperature in the allotted space does not exceed 104°F (40°C).
POWER STATUS
Model AD-1616
Audio Distribution 16x16 DSP Matrix
6”/15cm 6”/15cm
6”/15cm
To Next Page
Loading...