AUDIO DISTRIBUTION
Technical Support: support@rticontrol.com - Customer Service: custserv@rticontrol.com 24
Option Description
DSP Preset
This option applies a custom DSP preset that is created and set in the EQ Settings
section of this GUI. The multi-band equalizer can be used for a number of purposes,
from adjusting the sound quality to account for an output’s response, to setting
personal preferences for listening to audio in a particular style, or to set high/low-pass
lters for creating bi-amping or subwoofer setups. Choose from up to 9 saved presets.
Mono/Stereo
Set this option to choose what listening mode each zone will use.
• Stereo: In this mode, audio outputs are treated as a pair with the Left and
Right outputs of a zone are routed specically to the Left and Right audio
inputs of a source. If a source only has a single Left or Right connection to this
matrix, only the respective Left or Right outputs will be active.
• Mono: In this mode, the Left and Right audio inputs from a source are summed
and output from both the Left and Right outputs of a zone.
Do Not Disturb
This feature is complimentary to the grouping capabilities of this matrix. When
zones are grouped with others in the Grouping section of this GUI, it may be
desirable to temporarily exclude one or more zones from having its audio source
or volume change inadvertently due to its group aliations. For example, if all
zones are part of a” Whole Home” group that links all zones together to listen
to the same audio source at specic volume levels, all zones will switch to the
specied source and have their volume levels adjusted to the group’s setting when
the “Whole Home” group is activated. If a user in one of these zones are actively
listening to a source and does not wish to be disturbed, the Do Not Disturb option
can be enabled that will temporarily exclude that zone from being aected by any
group activation that it is normally a part of, thus allowing the currently routed
source and volume to remain unaected for undisturbed listening.
• Enable: Enables Do Not Disturb mode and will not allow a zone from taking
part in any group actions.
• Disable: Disables Do Not Disturb mode and allows a zone to take part in any
group actions that it is currently assigned to.
Volume
Sets various volume parameters based on the settings for the primary and
secondary sources in the section above.
• Output Volume: Sets the zone volume level (relative) to a value from 0 -100.
• Startup Volume: Sets the startup volume level (relative) of the zone when the
matrix or zone is powered on.
To Next Page
Loading...