Configuring Wireless Settings
ZoneFlex P300 Wireless Bridge User Guide, 800-70956-001 Rev B 33
3 Click Update Settings to have the ZoneFlex P300 save your changes.
Wireless Bridge
Mode
Used to manually designate the unit as the root bridge or non-
root bridge.
By default, the
ZoneFlex P300 is configured to automatically
obtain an IP address from a DHCP server on the network. If the
ZoneFlex P300 does not detect a DHCP server, it automatically
assigns itself a static IP address to make it easier for you to
preconfigure and deploy it on your network. The default IP
addresses for the root bridge and non-root bridge (if no DHCP
server is available) are as follows:
• root bridge: 192.168.2.1
• non-root bridge: 192.168.2.254
Also refer to
Reversing Root Bridge and Non-Root Bridge
Roles
.
Export
Configuration
Only available from the root bridge Web interface. Use this link to
save a root bridge configuration file to an admin computer. This
configuration file can then be used to easily configure non-root
bridges with matching settings.
Table 6. Wireless settings (Continued)
To Next Page
Loading...
