Need help?Do you have a question about the Ruckus Wireless ZoneFlex 7731 and is the answer not in the manual?
General| Wireless Standards | 802.11a/b/g/n |
|---|---|
| Frequency Bands | 2.4 GHz, 5 GHz |
| Maximum Data Rate | 300 Mbps |
| Ethernet Ports | 1 x 10/100/1000 Mbps |
| Mounting Options | Pole, Wall |
| Device Type | Wireless Access Point |
| Form Factor | Outdoor |
| MIMO | 2x2 |
| Ingress Protection | IP67 |
| Product Type | Outdoor Access Point |
| Power over Ethernet (PoE) | 802.3af |
| Weight | 1.2 kg |
| Interfaces | 1 x Gigabit Ethernet |
| Antennas | Internal |
Outlines configuration procedures required before physically mounting the units.
Lists key configuration steps for setting up the wireless bridge.
Provides instructions for configuring two bridges for point-to-point bridging.
Details the steps for connecting the bridge using Power over Ethernet.
Explains the automatic provisioning process for bridge pairs.
Guides on preparing the computer for connecting to the wireless bridge.
Instructions on accessing the wireless bridge's web interface for management.
Steps to set the country code for regulatory compliance and optimal performance.
Procedures to confirm successful association between the root and non-root bridges.
Describes manual provisioning for additional non-root bridges in multipoint setups.
Details the physical installation process for the wireless bridge.
Tasks to optimize the wireless link performance after installation.
Procedures for aligning bridges to maximize signal strength.
Specific aiming steps for point-to-point bridge configurations.
Specific aiming steps for point-to-multipoint bridge configurations.
Process for scanning and selecting the optimal wireless channel.
Steps to verify the connection and signal integrity between bridge pairs.
Steps to access the wireless bridge's web interface using a browser.
How to change the default administrator username and password.
How to set up WPA2, WPA, or WEP encryption for the wireless bridge.
How to change the default administrator username and password.
Steps to restore the bridge to its original factory settings.
Using built-in tools like Ping and Traceroute to check network connections.
To Next Page
