92
Managing the Wireless Bridge
Enabling Other Management Access Options
4. Click Update Settings to save your changes. A confirmation message appears at
the top of the page.
Viewing FlexMaster Management Status
If you configure the bridge to be managed by FlexMaster, you can check the TR069
Status section on the Administration > Management page. Tab le 1 9
lists the TR069
status information that the bridge provides.
Pointing the bridge to FlexMaster
Your ZoneFlex device is required to “call home” to register with your FlexMaster;
FlexMaster does not initiate initial contact. To register successfully with FlexMaster,
your ZoneFlex device must know the FlexMaster server’s URL, thus entered on the
device.
To point the bridge to FlexMaster
1. Go to Administration > Management.
2. Under TR-069/SNMP Management Choice, click Auto.
3. In FlexMaster Server URL, type the URL of the FlexMaster server.
4. Toggle the Periodic FlexMaster Inform Interval drop-down list to select how
frequently the device will check the FlexMaster server for any pending configura-
tion changes available for that ZoneFlex unit.
Table 19. TR-069 status information
Status Information Description
Currently using URL Shows the FlexMaster server URL with which
the bridge is currently registered
Last attempted contact Shows the date and time of the bridge’s last
attempt to contact FlexMaster. Date and time
are specified in GMT (or UTC), which are
accurate if a Network Time Protocol (NTP)
server is configured.
Last successful contact Shows the date and time of the bridge’s last
successful contact with FlexMaster.
Current time Shows the current date and time as known to
the bridge. This timestamp is accurate if an
NTP server is configured on the bridge. If
there is no NTP server configured, this
timestamp is useful as a reference for
comparison of the timestamps for Last
attempted contact and Last successful
contact.
To Next Page
Loading...
