Ruckus Wireless ZoneFlex 7731 - Page 99

91
Managing the Wireless Bridge
Enabling Other Management Access Options
3. If you want to use TR-069 or SNMP to manage the bridge, configure the settings
listed in Tabl e 18 .
Telnet port This field lists the default Telnet port of 23. You can
manually change this port number, if required.
SSH access By default, this option is enabled (active).
SSH port This field lists the default SSH port of 22. You can
manually change this port number if required.
HTTP access By default, this option is enabled (active).
HTTP port This field lists the default HTTP port of 80, if HTTP
is active. You can manually change this port
number if required.
HTTPS access By default this option is enabled. This connection
mode requires a security certificate, a copy of
which has been pre-installed in the device.
HTTPS port This field lists the default HTTPS port of 443. You
can manually change this port number if required.
Certificate Verification This notes whether the security certificate linked
to the HTTPS settings has been passed or not.
Table 18. TR-069 and SNMP Management Options
Option Description
Auto Enables the ZoneFlex device to connect to either
SNMP server or Ruckus Wireless FlexMaster.
SNMP only Only allow SNMP management
FlexMaster only Only allow FlexMaster management
None Disable TR069/SNMP management
DHCP Discovery URL of server providing DHCP
FlexMaster Server URL URL of the FlexMaster server
Digest-authentication
Username/Digest-
authentication password
This information is automatically generated by the
bridge and used for authentication with
FlexMaster. Change this value only
if you want the
bridge to connect to another access control server
(ACS).
Periodic FlexMaster Inform
Interval
Interval at which the device should attempt to
contact FlexMaster
Table 17. Management Access Options
Option Description