Scheduling Automatic Firmware Upgrades
Upgrading Manually using a Local File
ZoneFlex P300 Wireless Bridge User Guide, 800-70956-001 Rev B 63
Scheduling Automatic Firmware Upgrades
You can use the Web interface to check for software upgrades for the firmware
operating the ZoneFlex P300. You can then apply these updates to the device in
one of two ways: (1) automating a regularly scheduled update, as described in this
section, or (2) manually l updating on an as-needed basis, as described in Manually
Upgrading the Firmware.
1 To upgrade the firmware image, go to Maintenance > Upgrade. The ZoneFlex
P300 Web GUI displays the Maintenance > Upgrade page (Figure 30).
2 In the Auto Upgrade? options, click the Enabled button
3 Enter the appropriate information in the Host name or IP address field.
CAUTION! Do not change any of the Image Control File, Username or Password
entries.
4 Verify that the Auto Upgrade? option is set to Enabled.
5 Tog g le th e Interval to Check for Software Upgrade drop-down list to select your
preferred interval.
6 Choose whether to reboot immediately after upgrading, or schedule the reboot
for a specific time of day using the Schedule Reboot Time After Upgrade list.
Choosing Any Time (the default value) results in the ZoneFlex P300 performing
a reboot immediately after the automatic upgrade is successful.
7 You have two options at this point:
• Click Perform Upgrade, which starts the process and the clock. The next
upgrade occurs at the selected interval.
• Click Save parameters only. The clock starts right away, and the actual
upgrade occurs at the first effective interval.
After you click one of these two options, a status bar appears during the upgrade
process.
When the upgrade is complete, the ZoneFlex P300 automatically reboots at the
time you specified in Step 6.
To Next Page
Loading...
