J Line Pump
Horizontal Double Suction Centrifugal Pump ā API 610 Process Pump
11 V1.032818
2.6 SAFETY INSTRUCTIONS RELEVANT FOR MAINTENANCE, INSPECTION AND ASSEMBLY
WORK
It is the plant operator's responsibility to ensure that all maintenance, inspection and assembly work is
performed by authorized and qualified personnel who have adequately familiarized themselves with the
subject in matter by studying this manual in detail.
Any work on the machine shall only be performed when it is at a standstill. To shut off the machine it is
imperative to follow the procedure for shutting down the machine as described in SECTION 7.5-
STOPPING.
Pumps and pump units that convey hazardous materials must be decontaminated before any
maintenance work is performed.
On completion of work all safety and protective facilities must be re-installed and made operative again.
Prior to restarting the machine, follow the instructions listed under SECTION 7.2-STARTUP.
2.7 UNAUTHORIZED ALTERATIONS AND SPARE PARTS
Modifications may be made to the machine only after consultation with a Ruhrpumpen representative.
Using spare parts and accessories authorized by Ruhrpumpen is in the interest of safety. The use of parts
not authorized by the dealer exempt the manufacturer from any liability, voiding the warranty.
2.8 UNAUTHORIZED MODES OF OPERATION
The reliability of the machine is guaranteed if and only if it is used in the intended manner, in
accordance with the statutes of this manual. The limit values specified in the data sheet must never be
exceeded under any circumstance.
To Next Page
Loading...