14 / 72
Horizontal End Suction Pump for Chemical Process, ASME B73.1-2001
Installation, Operation, and Maintenance Manual – CPP21
place. If stored under unfavorable climatic conditions, this protective period may be considerably reduced.
Should the anticorrosive layer become damaged, it can be repaired by repainting or respraying.
• Anticorrosive layers inside the pump housing must be removed with process
neutral solvents before commencing pump operation.
• When removing the protective coating with a neutral solvent, follow the safety
instructions of the solvent manufacturer carefully.
• The anticorrosive layer applied to the exposed parts does not need to be
removed before putting the pump into operation.
To Next Page
Loading...